Skip to content

Towing and pushback

Planning aid only. Results must be verified by a qualified airport engineer against manufacturer data and applicable regulations.

Press P or choose Pushback in the inspector.

Modes

  • Tug + towbar — the hitch leads; the aircraft trails the bar.
  • Towbarless — the hitch is locked to the nose gear.

Reverse paths (pushback, stand exit) run the same model backwards along the drawn line.

A push back from stand … to twy … command plans a nose-in hitch: straight back along the stand, then a turn onto the taxiway/taxilane behind the stand so the aircraft lines up for breakaway. The turn starts before that taxiway’s far pavement edge. If the turn needs more nose-wheel steering than the 50° generic design value, the path is still drawn with a warning to check the aircraft’s towing limit. The inspector accepts an optional aircraft max; exceeding it is also a warning, not a refusal. The command refuses only when the aircraft would leave the pavement, the tail would not clear, or no taxiway is found — it does not draw an invalid reverse across the taxiway.

Generic tug

Default tug length, width, wheelbase and hitch offset are round planning figures, not a named manufacturer model. Replace them with the operator’s ground-support data before design use. The inspector shows that warning.

Towbar default length is likewise a generic example.

What is not modelled

  • Tyre slip, steering limits, tug traction, slope, or manufacturer turn tables
  • Manufacturer jet-blast contours (the in-app layer is an estimate; import licensed GeoJSON or DXF to override)
  • A specific towbarless tractor kinematics manual

See Methodology.