Skip to content

Command bar

Planning aid only. Results must be verified by a qualified airport engineer against manufacturer data and applicable regulations.

The command bar sits at the bottom of the map. Type an instruction; SteerSim matches it against the aircraft list and the loaded airport. There is no AI service in this version.

Examples

  • Taxi A380 from twy C to stand V7
  • simulate an A380 taxiing via taxiway A and B to park at stand 501
  • push back A388 from stand V4 to twy A
  • push back A388 V4 to twy A
  • park A388 at stand 501
  • show jet blast for A388 at stand 501 breakaway
  • check clearances
  • switch to ICAO or switch to FAA
  • export report
  • set airport EGLL
  • A380 180 on the 34R turn pad at OTHH
  • B777 turn pad runway 16L end OTHH, turn left
  • clear

from and via are optional. Pushback also accepts from / at / off, optional stand / gate / the / an, and to / onto. Aircraft names resolve to FAA Aircraft Characteristics Database types (A380 / A388, 777-300ER / B77W, and so on). Taxiway and stand ids must exist on the loaded airport. Ambiguous or unknown names are not guessed — the bar names the token that failed and lists closest real refs (not applied). Unrecognised taxi / simulate / push / park / show commands show a short Did you mean line; open Show grammar for the full forms.

What a taxi or pushback command does

The planner traces taxiway and stand centrelines on the loaded map, draws the path, runs the same clearance checks as a hand-drawn path, and plays the aircraft along the route. Warnings never hide the rest of the path: the full route is drawn and listed with warning markers. A pushback from a stand turns onto the taxiway or taxilane behind the stand before reversing across that pavement. Steering above the 50° generic design value is a warning (the path is still drawn). The command refuses a pushback only for pavement-edge, tail clearance, or a missing taxiway, and refuses a taxi only when the map has no connection or a name is unknown. Clearance findings are warnings or verify items unless the taxiway is narrower than the main-gear span plus the required wheel-edge margin.

Jet blast (estimate) turns on the estimated jet-blast layer. See Methodology.

A turn-pad 180° command snaps the selected type onto the runway centreline at that end and runs exactly one 180° reversal at the generic 50° design steering limit (or the max you entered). It follows OpenStreetMap turn-guidance markings or a turning loop when mapped, otherwise the paved runway-end widening. A derived strip is last resort. After the run, a compact steering control on the map (and in Inspect) live-updates the swept path. Wheel-to-edge uses the same ICAO / FAA table as other runs. If the turn cannot keep the required outer-wheel clearance, the inspector reports that the 180° is infeasible and gives derived minimum pad and runway widths for this type. Overruns are shown in red. This is a planning aid, not manufacturer turning data.

The command bar stays available in full-screen / immersive map mode, including after a two-finger map rotation. On a phone, Inspect also has Runway turn pad 180° (runway end, auto / left / right, Run 180°, and advanced pad tools).

After routing, vertex handles stay hidden until you click the path or tap Edit path. Playback starts automatically along the full swept path, then stops parked. Turn Follow on to keep the aircraft centred.

Desktop and phone

  • Desktop: centred on the bottom edge of the map, above the timeline. Up-arrow recalls previous commands.
  • Phone: docked at the bottom of the map, above the draw toolbar and tab bar. The bar stays above the software keyboard.

/ focuses the bar. ? on the bar opens examples.