Drawing paths
Planning aid only. Results must be verified by a qualified airport engineer against manufacturer data and applicable regulations.
Paths are polylines, tangent arcs or splines in the local metric map (metres). They are not digitised from map-tile pixels.
Tools
Swipe to see all columns
| Key | Tool | What it does |
|---|---|---|
| V | Pan / Select | One-finger pan on touch; click vertices to drag. Drawing tools use two fingers to pan, pinch to zoom, and a two-finger twist to rotate. The compass resets north. |
| R | Runway | Two clicks for a runway centreline (width in the toolbar) |
| T | Taxiway | Centreline; set width in metres, Enter to finish |
| B | Apron | Polygon; three or more clicks, Enter to finish. Use this to draw a runway turn pad, then Run 180° in Inspect |
| L | Polyline | Click vertices; Enter to finish |
| A | Tangent arc | First two clicks set a tangent; later clicks add arcs at the toolbar radius |
| S | Spline | Click control points |
| P | Pushback | Same as polyline but tagged as a reverse manoeuvre |
| M | Measure | Two clicks; length in metres |
| [ / ] | Arc radius | −/+ 5 m |
Snap (toolbar switch) pulls clicks onto taxiway and runway centrelines, endpoints, and perpendiculars from the last point.
Edit
- Drag white vertex handles.
- Delete removes the selected path, fillet, stand or obstacle.
- Ctrl+Z / Ctrl+Shift+Z undo and redo paths, fillets, stands, obstacles and imported overlays.
- Esc cancels a draft and returns to Select.
The drawn path is the tracking line. Steering mode (cockpit-over-centreline vs judgemental oversteer) is set in the inspector.
Runway turn pad 180° in Inspect snaps the selected type onto a runway end, turns 180° once, and lines up the other way. Mapped OpenStreetMap turn-guidance or pad pavement is used when it exists; otherwise the runway-end widening. Draw a pad or derive a strip only from Advanced. The command bar also accepts this manoeuvre, including in full-screen map mode. A compact steering control on the map live-updates the path.
Undo coverage
Undo includes path geometry, obstacles, fillets, stands, imported overlays and hand-drawn aeroways. Inspector number fields (tug size, lead-in length) are not on the undo stack. Vertex drags snapshot once on pointer-down.